Stainless steel socket-head screws for mounting Adjust-A-Jaw® and Adjust-A-Body™ with Threaded Eye Tensioners and
Ultra-tec® Fixed Jaws.
Cap Screws
Thread
Used with hardware for cable diameters
Part No.
1/4-28
1/8", 3/16"
11HCS8
3/8-24
1/4", 5/16", 3/8"
11HCS12
Adjust-A-Ball (without counter bore)
Adjust-A-Balls are used with either our CSTS or threaded studs for angle compensation. These half round balls allow for the cable to swivel to any angle automatically. Simply drill the proper hole and the ball will adjust to the angled position as the cable is tensioned.
Adjust-A-balls will fit up to 1/4” cable. Holes in the outside of the end posts must be drilled to 11/16”. If using a flat bar as your end post, you counter sink the hole to a 11/16" diameter.
Adjust-A-Ball (without counter bore)
Ball Size
(s)
Hole Size
(t)
Part #
3/4"
25/64"
10HAB102
Adjust-A-Ball (with counter bore)
Adjust-A-Balls are used with our termination studs for stair angle compensation. These half round balls allow for the cable to swivel to any angle automatically. Simply drill the proper hole and the ball will adjust to the angled position as the cable is tensioned.
Adjust-A-balls will fit up to 1/4” cable. Holes in the outside of the end posts must be drilled to 11/16”. If using a flat bar as your end post, you counter sink the hole to an 11/16” diameter
