|
Login Status |
|
Not logged in
|
| » Login |
 Learn more about Discounts for Registered Contractors
and Fabricators HERE
|
View our Shipping and Return Policies HERE
|
Copyright © 2011
www.cableartinc.com
|
|
Railing Components
|
|
Drill Guide
Use the drill guide to drill your pilot holes. Clamp the guide to post and drill. Subsequent drills will follow pilot holes. When ordering, allow space for clamps. A 6” overall-length drill is included. |
|
Cable Support
1/4” x 1” flat bar cable supports are used to prevent the cable from biting into the wood post where the cable enters or exits a wooden post at an angle, when the cables are tensioned. Available in mill finish carbon steel or #4 finish stainless steel. |
 |
|
 |
|
|
|
Cable Brace
1/4” x 1” cable braces are used to support the cables between end or intermediate posts to keep the cable from flexing excessively when a load is applied. Cable braces attach to the top rail and to the lower mounting surface (a bottom rail or the deck). Available in mill finish carbon steel or #4 finish stainless steel. Also available for stairs. |
|
Corner Section Tubes
Available in carbon or stainless steel.
Order CORNER SECTION TUBE
and specify carbon or stainless,
cable diameter being used and
tube radius:
3.90” radius
4.00” radius
6.19” radius |
 |
|
 |
|
|
|
Stainless Steel Post Protector Tube
The post protector tube is inserted into a wood post where the cable enters/exits the post at an angle to keep the cable from biting into the wood. |
|
Cable Brace
Floor Plates
For mounting cable braces to top or bottom rail, stair, or deck. |
 |
|
 |
 |
|
 |
|
Back to Top of Page
|
|
