Adjust-A-Balls are used with either our CSTS or threaded studs for angle compensation. These half round balls allow for the cable to swivel to any angle automatically. Simply drill the proper hole and the ball will adjust to the angled position as the cable is tensioned.
Adjust-A-balls will fit up to 1/4” cable. Holes in the outside of the end posts must be drilled to 11/16”. If using a flat bar as your end post, you counter sink the hole to a 11/16" diameter.
Adjust-A-Ball (without counter bore)
Ball Size
(s)
Hole Size
(t)
Part #
3/4"
25/64"
10AH0102
Adjust-A-Ball (with counter bore)
Adjust-A-Balls are used with our termination studs for stair angle compensation. These half round balls allow for the cable to swivel to any angle automatically. Simply drill the proper hole and the ball will adjust to the angled position as the cable is tensioned.
Adjust-A-balls will fit up to 1/4” cable. Holes in the outside of the end posts must be drilled to 11/16”. If using a flat bar as your end post, you counter sink the hole to an 11/16” diameter
